Single Acting vs Double Acting Hydraulic Trailer Jacks
Share
The right jack depends on your pump. Single acting pumps push oil one way. Double acting pumps power both directions. Buy the jack that matches.
| Single acting Atlas | Double acting Atlas | |
|---|---|---|
| Pump | Single acting hoist pump | Double acting power unit |
| Extend | Hydraulic | Hydraulic |
| Retract | Compressed air charge (NeXgen adapter) | Hydraulic |
| Holding | Pump circuit | 7:1 pilot-operated check recommended |
| Hoses to jack | One | Two |
| Best for | Simple dump trailers with SA hoists | Trailers with DA power units; tandem jacks |
How the single acting Atlas retracts
Most single acting jacks use a spring to retract. Springs wear out. The single acting Atlas, the trailer industry's first, uses compressed air instead. The NeXgen single acting adapter comes installed on the jack's retract port. Charge it once with air and the jack retracts on its own when you release pressure.
Setting the air charge
- Fill the adapter to 80–125 PSI with an air compressor.
- Check it with a 150 PSI gauge.
- Spray the fitting with soapy water to check for leaks.
- If you remove the adapter, bleed the air first. Reinstall at 300–340 in-lb with an 11/16" wrench.
Full steps: Single acting Atlas installation guide. The story behind it: Singled Out.
Why the double acting Atlas wants a check valve
A double acting jack is driven both ways. A 7:1 pilot-operated check valve locks oil in the cylinder. The jack holds its position under load until the pump drives it again.
Which should you buy?
- Single acting hoist pump: buy the single acting Atlas.
- Double acting power unit: buy the double acting Atlas.
- Two jacks working together: go double acting and add a flow divider. See Tandem Hydraulic Jacks.