How to Convert a Dump Trailer Crank Jack to Hydraulic

Your dump trailer already has a hydraulic pump. A hydraulic jack puts it to work on the tongue too. No more cranking a loaded trailer by hand.

What you need

Item Notes
Atlas hydraulic jack 26" stroke, #6 SAE ports. Lifts up to 10,053 lb at 3,200 PSI.
Conversion kit Hose and fittings sized to your trailer: single acting (39", 48", 60") or double acting.
Pump Your existing dump trailer power unit, or a Stillwell SJP-360. Max 3,200 PSI.
Tools Wrenches, plus a welder or mounting bolts.

Step 1: Pick single or double acting

Match the jack to your pump. A single acting hoist pump pairs with the single acting Atlas. A double acting power unit pairs with the double acting Atlas. Not sure which you have? See Single Acting vs Double Acting Hydraulic Trailer Jacks.

Step 2: Mount the jack

Remove the crank jack. Bolt or weld the Atlas to the tongue. Welds should follow AWS D1.1. Each leg is rated for 12,000 lb of tongue weight.

Step 3: Plumb it

Run hose from the pump to the jack ports. Facing the jack, the right port extends and the left port retracts. The conversion kit includes the hose and fittings for your trailer length.

Step 4: Bleed the air

Cycle the jack in steps: 6.5", 13", 19.5", then the full 26".

Step 5: Check power

Over 90% of support calls trace to the battery or ground. Use a charged battery and a clean, solid ground before you troubleshoot anything else.

Care tip: Do not grease or oil the jack tubes. Lubricant collects dirt.

The Atlas carries a 2-year warranty. Full instructions: Atlas installation guide.

Shop dump trailer hydraulic jack kits

Back to blog