How to Choose Hydraulic Hose for a Trailer Jack

Get four things right: size, pressure rating, end fittings and length. Miss one and you get leaks, slow jacks or a burst hose.

1. Size

3/8" hose matches the #6 ports on the Atlas jack. It carries enough flow for full jack speed without bulk.

2. Pressure rating

Look at working pressure and safety factor, not just the number on the hose. NeXflex is SAE 100R17, rated 3,000 PSI working pressure with a 4:1 safety factor (12,000 PSI minimum burst).

The 3,000 PSI rating is for continuous running pressure. A jack circuit never runs there continuously; it reaches peak pressure only briefly at the end of a stroke. That makes NeXflex a safe match for Atlas jacks and pumps up to 3,200 PSI, including the SJP-360.

3. End fittings

NeXflex assemblies have #6 female JIC swivels on both ends. The swivel lets you tighten the hose without twisting it. The jack's #6 SAE ports take a #6 SAE-to-JIC adapter, included in our hose and adapter kits.

4. Length

Measure the actual route, not the straight line. Leave slack for tongue movement and turns. Avoid sharp edges and hot surfaces. NeXflex is sold in 6" steps from 12", so you buy the length you need.

NeXflex at a glance

Spec NeXflex
Hose 3/8" SAE 100R17
Rating 3,000 PSI working, 4:1 safety factor
Ends #6 female JIC swivel, both ends
Lengths 12" and up, in 6" steps
Built Assembled in Cleburne, Texas

Converting a crank jack? Start with How to Convert a Dump Trailer Crank Jack to Hydraulic.

Shop NeXflex hydraulic hose · Hose and adapter kits

Back to blog